Rick ⁽¹⁶⁶⁾

I have enough fiberglass on the new section of trunk lid to make it good and strong. It just needed some sanding and it is about done.

Still working on the trunk lid. I have it thick enough now to be nice and strong. It is pretty close to level now and you can finally start to see what it is going to look like. I haven’t had much time to mess…

It has been cold and terrible weather for fiberglass work so not much has been done the last week or so. But the weather is looking better now so it is time to get the work on the trunk lid going again.

I didn’t get much time today to work on the car but I managed to get a few things done. First thing was level out the new trunk lid lip. I started by clamping a pvc pipe to the back to hold the slight curve…

After spending a few days measuring and trying to find the best square on the trunk lid I managed to get a line that looked pretty good. So today it was time to cut the trunk lid and get started shaping it to be set up the way I am wanting. It was pretty quick to cut, I just used a jigsaw and followed my line around the whole thing.