The car has been sitting around not getting much of anything done to it other than using it as a table. The problem I have is if it is in the main part of my shop it is in the way of anything else I need to work on but once I put it off […]
Category: Aero Metro XFi
I need to get the layout on where everything goes figured out. So before I start making the flange for the trunk lid to seal against I need to come up with how the rest of the stuff is going to fit. The first thing is the wall for the storage area. I used plastic […]
With the trunk lid cut free and the back of the car mounted I need to get it all squared up good before I can build inner fenders and stuff. I tried a few different things to get everything to sit square and finally came up with a way to get it all lined up. […]
I worked out how to attach the hinges to the roll bar. It was hard to get them lined up and attached. I ended up bolting a plate onto the hinges and welding the plates on to the roll bar after I got it lined up right. After getting it welded in place and making […]
Managed to get the trunk lid cut apart today. It didn’t take long to get it apart and the lower section bolted down solidly. After checking it for square it seems to sit on the frame pretty well. I will probably end up making new inner fenders and seal off the whole back area to […]
I have enough fiberglass on the new section of trunk lid to make it good and strong. It just needed some sanding and it is about done.
Still working on the trunk lid. I have it thick enough now to be nice and strong. It is pretty close to level now and you can finally start to see what it is going to look like. I haven’t had much time to mess with the car but that just gave the fiberglass plenty […]
It has been cold and terrible weather for fiberglass work so not much has been done the last week or so. But the weather is looking better now so it is time to get the work on the trunk lid going again.
I didn’t get much time today to work on the car but I managed to get a few things done. First thing was level out the new trunk lid lip. I started by clamping a pvc pipe to the back to hold the slight curve I need. I tried measuring out a straight line for […]
After spending a few days measuring and trying to find the best square on the trunk lid I managed to get a line that looked pretty good. So today it was time to cut the trunk lid and get started shaping it to be set up the way I am wanting. It was pretty quick […]