MetroXFi.com

Metro Information

I am slowly putting all the information I have gathered over the years and will post it here as I write it up. So far there is not much here but over time I will keep adding more and hopefully over time I will have a pretty useful database of information here.

4 Responses to “Metro Information”

  1. 1
    tbucket Says:

    Metro idles smooth for 5 seconds then rough for 3seconds, it will just keep cycling like this. Every now and then it will stall. Thanks ,tbucket

  2. 2
    Brad Davis Says:

    I had this problem too. mine would all the sudden act like it was running out of gas sometimes too. I replaced the MAF. this makes sense because if MAF is intermittently bad, it will not sense accurate vac pressure, therefore cutting fuel back. do your homework on this if you buy it new, i found one for $145 at one place, $74 at another. got one at salvage for $5 :)
    Brad

  3. 3
    Eric Says:

    NO need to replace the MAF sensor! Just clean off the small thin wires with electronics cleaner!!

  4. 4
    ken Says:

    How can I tell if a 5 speed manual is XFI? Are there some numbers/codes on it.

    ken

Leave a Reply

© 2008 MetroXFi.com | Entries (RSS) and Comments (RSS)

Green Web Hosting! This site hosted by DreamHost.wordpress logo