Throttle Trigger Mounted

Another day without much being accomplished. But at least there is some progress.

100_0576 100_0575

I wired up the hall sensor to the controller and tried it out. The trigger is much smoother than the game controller joystick. The gauge layout seems ok but the position is a bit wrong. I will adjust the size and spacing and get it set up nice. I am thinking of putting a motor temperature display on there as well so I can monitor the motor temperature. The controller already monitors motor temperature but having a display would be nice. Also the switch to change to the gas pedal from the trigger will probably be taken off. The trigger pull is very smooth so I am not sure if I really need it.

Hopefully I will get my shortened struts next weekend and I can more or less finish up the mechanical part of the car. It is really close to being done just a few odds and ends that are taking forever 🙂

Updated: March 29, 2009 — 5:05 pm

Leave a Reply

Your email address will not be published. Required fields are marked *

two × 2 =

MetroXFi.com © 2013 Frontier Theme